Circuit design and component selection that precede layout, turning a concept into a verified, ready-to-build schematic.
Before a board can be laid out, the circuit itself has to be right. Our electronics design service covers schematic capture and component selection, choosing power stages, analog front-ends and connectors that meet your requirements and are actually available to source, not just correct on a datasheet.
We back circuit choices with tolerance and derating analysis so the design holds up across temperature, supply variation and component aging, and we hand off a schematic and BOM that's ready for PCB layout, either through our own PCB Design service or your own team.
Where circuit design most often goes wrong, and what we check for.
Every part we select is checked against sourcing and availability, not just electrical fit on a datasheet.
Simulation results are validated against real-world tolerances, parasitics and component variation before sign-off.
Power and signal budgets are calculated and documented so there are no surprises once the board is built.
We document why each key component and topology was chosen, so the next engineer isn't left guessing.
Power, analog and digital circuits captured as clean, well-labeled schematics ready for review and layout.
Parts selected on electrical fit, availability, lifecycle and lead time , not datasheet specs alone.
Power consumption, thermal margin and signal integrity budgeted and verified before layout begins.
We define electrical requirements and select a circuit topology to match.
Circuits captured with component selection reviewed for fit and sourcing.
Power and signal budgets verified against tolerances before sign-off.
Reviewed schematic and BOM delivered, ready for PCB layout.
A layout-ready schematic and bill of materials, checked and sign-off ready.
Documented reasoning behind key component and topology choices, with reference datasheets.
Yes, through our PCB Design service, we take a reviewed schematic straight into layout. If you prefer, we can also hand off a reviewed schematic and BOM to your own layout team.
Yes, we review existing schematics for component selection, power budget and design issues before they move to layout or fabrication.
Yes, component selection includes a sourcing and availability review, so the parts on your BOM are ones you can actually buy.
Send us your requirements or existing schematic, and we'll scope the design or review.
Discuss Your Project