Control systems and sensor networks that keep manufacturing and process lines monitored, controlled and running.
Automation projects live at the intersection of electrical panels and software logic. We design and build PLC- or microcontroller-based control systems and the sensor networks that feed them, wiring relays and driver modules, reading process variables, and turning raw signals into control decisions that keep a line running safely and consistently.
Much of our automation work is retrofitting: adding monitoring and control onto equipment that already exists on your floor, without a full line replacement. We assess what's there, design the control and sensing layer around it, and integrate cleanly with existing electrical and mechanical systems.
Where automation projects most often stall, and what we address.
Operators walking a line to check readings that a sensor network could catch earlier, and continuously.
Machines that run fine but report nothing, no data on cycles, faults or process variables.
Panels and programs nobody fully understands anymore, making changes risky and slow.
Automation that needs both wiring and firmware expertise, handled as one project instead of two handoffs.
PLC or microcontroller-based control logic designed around your process, wired to the relays and drivers that move it.
Process line sensors wired, networked and fed into a control or monitoring system that gives you visibility.
Automation and monitoring added onto equipment already in service, without a full line replacement.
We review your existing equipment, process flow and control requirements on site.
Control logic, sensor placement and wiring designed around your process.
Panels, sensors and control logic built and integrated with your equipment.
System tested on your line and handed over with documentation your team can operate from.
Wiring diagrams, control logic documentation and panel layouts for your records and future maintenance.
A commissioning report and operator walkthrough so your team can run the system confidently from day one.
Yes, retrofitting is a large part of our automation work. We design control and sensor systems around your existing equipment rather than requiring a full line replacement.
Both. We choose PLC or microcontroller-based control based on what fits your application, budget and maintenance preferences.
We hand over full documentation so your team can maintain the system independently, and we're available for support and changes as your process evolves.
Tell us about your process line and equipment, and we'll scope the control and sensor design.
Discuss Your Project