Multi-layer layout and design-for-manufacture review that turns a schematic into a board you can build.
A schematic is only half the design. Our PCB design service takes verified circuits through layout, stack-up planning, signal and power integrity checks, and design-for-manufacture (DFM) review, so the board that comes back from fabrication works the first time.
We lay out boards for microcontroller carriers, sensor front-ends, power modules and IoT devices, sized for both prototype runs and production panels.
Where PCB design most often goes wrong, and what we check for.
Trace widths, clearances and via sizes reviewed against your fabricator's capabilities before you order.
Layer stack-up, ground planes and decoupling placed to keep sensitive signals clean.
Component footprints and placement reviewed for automated assembly and hand rework alike.
Mechanical fit, connector placement and enclosure clearance checked against your prototype early, not after fabrication.
Component placement, routing and layer stack-up derived directly from a reviewed schematic.
Design-for-manufacture and design-for-assembly checks before a board goes to fabrication.
Impedance-aware routing, ground plane strategy and decoupling for clean signals and stable power.
We confirm the circuit is layout-ready before routing begins.
Placement, routing and layer planning for signal and power integrity.
Manufacturability check against your chosen fabricator's rules.
Gerbers, BOM and assembly drawings delivered, ready to order.
Gerbers, drill files and stack-up documentation ready for your PCB fabricator.
Bill of materials, pick-and-place data and assembly drawings for your assembler.
Both. If you already have a reviewed schematic we can start directly at layout; most projects come to us through our Electronics Design service first.
We design to standard capability tables and can target whichever fabricator you prefer to use, or recommend one based on your board's requirements.
Yes, we review existing layouts for signal integrity, power and manufacturability issues and revise as needed.
Send us your schematic and requirements, and we'll scope the layout and DFM review.
Discuss Your Project